Problem Red taito space invaders pre flight checks

[Ronnie Dent]

Just picked up this taito si! Been stored for many years! (They are still out there)
Previous owner stripped all the loose bits cpo marquee bezel coin door and rear door! And has misplaced them but assures me he still has them!
Anyway I’m not even sure what it’s called? Space invaders part 2, it’s colour I think?
I removed the 2 edge connectors and powered it on from a distance no magic smoke or sparks the screen had a nice luminance but after a few mins I could hear a high pitched whine appear looked at the screen and had a green band down the middle? Have in plugged it for now! It’s a toei screen guessing it would badly need a cap kit for starters
So tried to find pinouts for the 3 stack game board but not sure which I need? Pin 6 looks too be 12v both parts and solder side but the parts side has no pin? So gave up there, can’t see any test points on the psu, there use to be a great site that covered these and vector games but I can’t find it!
It was something like bravo? Or at least had a B in it lol.

So question is where do I start with it lol? Want to at least check the psu voltages before powering up?
Thanks for any advice

Couple pics for now

Please

 

[bones]

Um, stack defo looks like SI part 2 which means it's colour so you could make up the 2 looms and test the pcb on a normal set up. Pinout

 

[bones]

Pinouts are available in any downloadable manual for the SI part 2. I would imagine that a manual for the upright cab version would have the psu plug info too.

 

[Ronnie Dent]

Pinouts are available in any downloadable manual for the SI part 2. I would imagine that a manual for the upright cab version would have the psu plug info too.

Cheers will have a look for some pdf manuals only ever had the l shaped version before