jerryspaghetti
Active member
Looking for some guidance on the following...
I have a couple of monitors in U4 cabs and the Toei chassis' were dead beyond repair or missing altogether. So after a good bit of research, I bought a couple of compatible MS9 chassis to use as replacements as the tubes are in beautiful condition with zero burn.
In effect its a similar process to a yoke swap but the yoke plug from the tubes are a different size/layout to the MS9 socket/pins so my question is what's the best solution here? Are there replacement MS9 plugs that I can get and crimp the pins?
For clarity the two tubes I have are:
Any advice greatly appreciated.
I have a couple of monitors in U4 cabs and the Toei chassis' were dead beyond repair or missing altogether. So after a good bit of research, I bought a couple of compatible MS9 chassis to use as replacements as the tubes are in beautiful condition with zero burn.
In effect its a similar process to a yoke swap but the yoke plug from the tubes are a different size/layout to the MS9 socket/pins so my question is what's the best solution here? Are there replacement MS9 plugs that I can get and crimp the pins?
For clarity the two tubes I have are:
| Hitachi A59KFS61X10 |
| Toshiba A59JMZ90X |
Any advice greatly appreciated.
Last edited: