RGB-Pi 6 Button Setup

[sapporo46]

Does anybody have experience of enabling button 6 for P1/P2 on one of these?

The instructions say to cut J1 and J2, I have identified then but I'm not exactly sure what needs to be cut (or how!).

Thanks

 

[Sp33dFr34k]

You literally just need to cut the trace inbetween

 

[sapporo46]

Presumably just the one I've highlighted?

 

[Martinmurphy30]

No, the jumper j1 looks like a capital letter I, cut the middle part so that you can bridge it again to disable button six....hope that makes sense...

 

[Retroman839]

 

[Sp33dFr34k]

Yes, like indicated above indeed.

 

[sapporo46]

Continuing my stupid questions - what should I use to cut the trace? I've been hacking at it with a razor blade but it's not going well.

 

[Retroman839]

Scalpel

 

[Flinnster]

Hey yeah all my cabs are chamma so I'm pretty sure I did this on mine. You have to do that pin / connect on both sides if you have a 2 player control panel of course.
A very thin screwdriver, or an art craft knife will often do the job to split the metal trace enough.