Oops will this still work lol

B

bones

Active member
Feedback
15 (100%)
Credits
1,626CR
Total carnage, won't be offering my services lol, good job it was a scrap pcb. Tried solder sucker first then desolder station then was peed off so attacked it with heat gun which was probably too high but by then I was mentally unstable and considered hacksawing it out. In fact it was a case of getting it off of the pcb no matter what the damage. Even though the chip and board were buggered I experienced a brief moment of satisfaction almost euphoric I'd say then thought it was probably best not to work on my faulty pcbs until I'd at least slept. Anyway there's a free big chip going if anyone has the ability to test it haha hoho heehee.
 
TheDaddy

TheDaddy

Senior Member
vacBacker
Feedback
14 (93%)
Credits
6,890CR
bones said:
Total carnage, won't be offering my services lol, good job it was a scrap pcb. Tried solder sucker first then desolder station then was peed off so attacked it with heat gun which was probably too high but by then I was mentally unstable and considered hacksawing it out. In fact it was a case of getting it off of the pcb no matter what the damage. Even though the chip and board were buggered I experienced a brief moment of satisfaction almost euphoric I'd say then thought it was probably best not to work on my faulty pcbs until I'd at least slept. Anyway there's a free big chip going if anyone has the ability to test it haha hoho heehee.
Click to expand...

Lol happens mate sadly , I over heated a board the other day after removing 15 odd chips with no issues.

Dave.
 
Del Griffith

Del Griffith

Active member
vacBacker
Feedback
15 (100%)
Credits
802CR
I'm certainly no expert but if a heat gun has done that to the chip it's probably fubar'd. You never know though, Worth trying it and saying a little prayer 🤞
 
You must log in or register to reply here.
Top